ideola's garagegroup buysAboutdownloadscontact

Shop by Brand

Upgrade Menu
Engine Mods
Boost Solutions
EFI Solutions
Electrics Upgrades
Suspension Upgrades
Exhaust Upgrades

Maintain Menu
Tune-up Kits
Engine Rebuild Kits
Cooling System Kits
Clutch & Trans Kits
Brake Kits
Appearance Packages
Tools & Equipment
Supplies

Used Parts Menu
Body & Trim Bits
Engine Bay Equipage
Exhaust Extravaganza
Gauges Galore
Interior Inventory
Suspension Swag

No PayPal? No Problem!


Appearance Packages

In this section: Center Dual Gauge Pod || MOMO Steering Wheels || Hood Liners || Weather Seals || Seat Reupholstery || Dash Recover Kits

Exclusive! Center Dual Gauge Pod
These gauge pods are hand-crafted for Ideola's Garage by long-time 924board member Claude Pellerin. They are designed fit perfectly in the center speaker pod location of the early 924 and 944 dash. The are constructed from ABS plastic and are designed to be "glued" into place with black RTV sealant.

There are two versions available: one version keeps the gauge faces in the same plane as the gauges just below in the OEM center console; the other version angles the gauges about 5° toward the driver for easier viewing at speed.

These gauge pods are designed to accommodate the standard 52mm (small) gauges, and are ideally suited for adding boost gauges, AFR gauge, volt meter, oil temp gauge, etc.

See our great selection of MOMO steering wheels below. Looking for a MOMO product you don't see? We can probably get it...just ask!
Ideola's Center Dual Gauge Pod
Black only. Suitable for all 1977-82 924/931 2.0L, 1982-85.5 944, and 1986-88 924S. Angled version now back in stock!
$
Ideola's center dual gauge pod
Straight binnacles on left
Angled binnacles on right
Gauge for comparison only (not included!)

Ideola's center dual gauge pod
Angled center dual gauge pod, wrapped in Alcantara by Classic 9 Leathershop, and installed in our 931 Club Sport

MOMO Steering Wheels New! We also sell MOMO Shifter Accessories!
New! Mod.80 Evo (Suede or Leather)
Our favorite aftermarket steering wheel for the 924! MOMO Racing Steering Wheels are specifically designed and manufactured for Formula and Prototypes motorsport requirements. Anticorodal aluminum structure. Covered in leather or suede, glued and not sewn to provide the most comfortable grip. Offered in small sizes that improve ingress and egress in the 924 and 944 series.
  • Diameter 350 mm
  • Anatomic grip rim section
  • Thumb buttons for horn
  • Top Grain Leather or Suede
  • Can be used with MOMO hub
$
MOMO Mod.80 Evo
MOMO Mod.80 Evo in Leather

New! Prototipo
The Porsche Classic!!! The Prototipo rim is wrapped in top grain black leather. Available with silver or black spokes. Black horn button with arrow momo logo. A MOMO hub is required for installation.
  • Style: Tuning
  • Color: Black
  • Screw: Black
  • Material: Leather
  • Spoke Finish: Black or Silver
  • Stitch: Whiter
  • Horn: Large Black Arrow
  • Diameter: 13.78 in (350 mm)
  • Rim Diameter: 1.18 × 1.18 in (30 × 30 mm)
  • Weight: 2.5 lbs (1.13 kgs)
$
MOMO Prototipo with black spokes
MOMO Prototipo with black spokes

New! Mod.88 D-shaped
The Mod.88 D-shaped is another great option from MOMO that makes it easier to ingress and egress the 924/944 cockpit. Covered in leather or suede, glued and not sewn to provide the most comfortable grip.
  • 320MM or 350MM
  • D Shape Design
  • Includes horn button
  • Suede
$
MOMO Mod.88
MOMO Mod.88

New! 8010 Steering Wheel Hub
The classic Porsche hub required to install MOMO steering wheels in your 924 or 944 series.
$
MOMO 8010 Steering Wheel Hub for Porsche
8010 Steering Wheel Hub for Porsche

New! QR6 Quick Release Hub
Looking for even easier ingress and egress? How about the ultimate anti-theft device?! The MOMO QR6 quick release hub is light weight, extremely precise and only indexes 1 way. Zero slop or play in this quick release hub. Engineered and designed to provide the racer with the highest quality quick release hub on the market. This hub has a tapered kidney shaped socket that eliminates the chances of developing any axial or longitudinal play. The MOMO quick release is equipped with spring loaded roll pins that allow for easy single hand removal and simple push to lock design. All components are precision machined from aircraft grade aluminum, anodized and designed to work with
the standard 6 bolt pattern found on all MOMO steering wheels.
$
QR6 Quick Release Hub
QR6 Quick Release Hub

Hood Liner Heat Shields
These hoodliners are hand-crafted by Classic 9 Leathershop from a high quality .25" thick Vinyl Nitrile material that holds up much better than the OEM hood pads. This material keeps the exterior of the hood cool and will not reflect engine heat back down toward your intake. They are light, about 11 ounces on average, are fire retardant and insulate against sound and heat. Material is available in black only.
Hood Liner Material Closeup Decal sample
You can wash the liner and hose it off. Since the material is made for aircraft firewalls and bulkheads and is FAA approved for aircraft, its extremely light, and unlike the factory liner will not absorb water and resists mildew. It has a closed cell texture on one side and a smooth finish on the other. These hood liners are custom cut specifically for the various shapes of the 924, 931, 944, and 928 hood liner cutouts. Various decals are available in white, silver, red or blue: Porsche crest, the model number, and Porsche racing script. Click images below for closeup of material and examples of the various decals
Hood Liner for 924, 931, 924S, 944, 951 & 928
NOTE: the 928 hood liner includes both the upper nose and lower main section. After ordering liner, you may add decals using the form below
 $
Decal Options
 $
Hood Liner for 924/944
Hood Liner for 924, 931, 924S, 944 and 951

Replacement Weather Seals
Sick and tired of noxious fumes being sucked into your cockpit? Or how about those annoying leaks around the sunroof seals that are ruining your seats and carpet? Can't stomach the cost of OEM seals at over $100 each?!?!?! These replacement seals are as good as OEM at a fraction of the cost!

A cracked or broken rear hatch seal will allow exhaust fumes to enter the car while driving. Air coming off the rear of the car will spin upwards and back towards the car and exhaust fumes will actually be pushed into the car through the hatch. If you smell exhaust fumes while driving this is most likely the cause. It will also allow extra noise in the car. Depending on how bad you rear hatch seal is, it can quiet your car considerably. It will also keep water sealed out. A new rear hatch seal will also keep your interior cleaner, keeping dust and dirt out. All this for about half the price of the original. It’s super easy to install. The old one just pulls off and the new one just pushes on. Installation takes about 5 minutes and can makes a big difference.

The other important cabin seal is in the rear of the engine bay, and separates the engine bay from the AC blower fans. If this seal is leaking, or missing, fumes and air from the engine may flow into the AC blower fan and directly inside the car. This will help keep engine smells out of the interior of the car. This seal replaces Porsche part # 92851114104.

The sunroof seals replace Porsche part numbers 944-564-114-01, 944-564-114-04, and 944-564-114-05. This seal is the sunroof seal that attaches to the sunroof. It’s the main problem in a leaking sunroof.

Over time the seals become dried out and/or crack and break, allowing water to enter the car. The original Porsche sunroof seal is a cut length of seal, not a solid loop like ours. We believe this aids in the seal not fitting right and over time will allow the seal to leak. The original seal can shrink, or get distorted on the ends, allowing water to enter the car. Our seal is a solid, one piece seal that’s been cut to the right size, looped and welded together, eliminating this future problem. Cracks and gaps in the seal are the easiest way for water to get into the car through the sunroof. So if your sunroof is leaking, or you have a gap where the seal comes together, you will need a new seal. Our seal is about half the cost of the original seal, a better design and has free shipping(inside the US).

Since our seal is a new seal you will notice a little difference in your car’s sunroof once installed. The new seal is not compressed yet like the old seal is (20+ years of compression), and this could make the sunroof not sit as flush as it used to. We have noticed that over time the seal will compress and the sunroof will sit more flush again. This is the case with the OEM seal and ours, but this seal tends to sit more flush than the OEM does.
Rear Hatch Seal
Suitable for all 924, 931, 944, 924S, and 951 
$
Rear Hatch Seal
Rear Hatch Seal


Hood Seal
Suitable for all 924, 931, 944, 924S, and 951 
$
Hood Seal
Hood Seal


Main Sunroof Seal
Attaches to the sunroof itself. Suitable for all 924, 931, 944, 924S, and 951 
$
Main Sunroof Seal
Main Sunroof Seal


Secondary Sunroof Seal
Attaches to the sunroof opening on the chassis. Suitable for all 924, 931, 944, 924S, and 951 
$
Secondary Sunroof Seal
Secondary Sunroof Seal

Front Seat Reupholstery Kits
These front seat reupholstery kits are hand-crafted by Classic 9 Leathershop from the finist Alcantara, Leather or German vinyl available. All kits include covers for seat cushions and backrests for two front seats. Regular welt may be stitched along the edge or the edge can have a French seam. Perforated seat inserts are also available.

COLOR CHARTS: Alcantara | Leather | Vinyl

Seat Reupholstery Kits
Left to Right: 928, Late 944, early 944 / 924
Vinyl Reupholstery Kit
 
$
Leather Reupholstery Kit
 
$
Alcantara Reupholstery Kit
 $ Add Perforated Insert Option
$

DIY Dash Recover Kits
These front dash recovering kits are hand-crafted by Classic 9 Leathershop from the finist Alcantara, Leather or German vinyl available. They also include the necessary defroster trim piece. The Late 944 kits include foam underlayment material and instructions for repair and installation. Pricing includes installation, as these kits are not recommended for DIY. Please contact us for DIY pricing or to arrange shipping of your dash core to Classic 9.

Dash Cover for Early 924/944

Dash Cover for Early 924/944 Dash Cover for Early 924/944
Details of Early 924/944 Dash in Leather

Dash Cover for Late 944
Late 944 Dash in Black & Linen Leather

Defroster Trim Piece for 924/944
924/944 Defroster Trim Piece

COLOR CHARTS: Alcantara | Leather | Vinyl

Early 924/944 Dash Kit
Vinyl
(select main color & stitching color)

 
$
Leather (select main color & stitching color)
 
$
Alcantara (select main color & stitching color)
 
$
Late 944 Dash Kit
Vinyl (select main color & stitching color)
 
$
Leather (select main color & stitching color)
 
$
Alcantara (select main color & stitching color)
 
$
Late 944 Dash with Airbag Option
$
Classic 9 Leathershop

about ideola's garage || group buys || downloads || contact ideola || Copyright © 2009-2013, Ideola New Media. Ideola is not associated with Porsche Cars North America in any manner. All pictures and references to the Porsche name, and the car names and shapes are for restoration reference only, and do not imply any association with PCNA.